进口铸钢气动隔膜泵(德国巴赫泵业)

 进口铸钢气动隔膜泵

进口铸钢气动隔膜泵概述：Introduction of imported cast steel pneumatic diaphragm pump:

即能抽送流动的液体，又能输送一些不易流动的介质，具有自吸泵、潜水泵、屏蔽泵、泥浆泵和杂质泵等输送机械的许多优点。

The flow of liquid can be pumped, and easy to transport some of the flow medium, has many advantages such as self suction pump, submersible pump, shield pump, pump mud and impurities such as transportation machinery.

进口铸钢气动隔膜泵特点：Characteristics of imported cast steel pneumatic diaphragm pump:

1、不需灌引水，吸程高达7m，扬程达50m，出口压力≥6kgf/cm2; 
2、流动宽敞，通过性能好，允许通过最大颗粒直径达10mm。抽送泥浆、杂质时，对泵磨损甚微; 
3、扬程、流量可通过气阀开度实现无级调节（气压调节在1-7kgf/cm2之间）; 
1, without irrigation water, suction lift up to 7m, the head of 50m, the outlet pressure is greater than or equal to 6kgf/cm2;

2, flow spacious, through good performance, allowing the maximum particle diameter of 10mm. Pumping mud and impurities, little wear on the pump;

3. The head and flow can be stepless regulated by the valve opening (air pressure is between 1-7kgf/cm2);

进口铸钢气动隔膜泵技术参数：Technical parameters of imported cast steel pneumatic diaphragm pump:

流量：0-30m3/h； 扬程：0-50m； 口径：10-100mm；

温度：-15-+120℃； 压力：0.1-0.7MPa； 自吸高度：5-7m。

进口铸钢气动隔膜泵工作原理：Working principle of imported cast steel pneumatic diaphragm pump:

当压缩气体进入配气阀，配气阀会将压缩气体压入泵其中一腔从而推动隔膜片运动挤压液体流出，然而泵的另一腔泵因为被拉出而吸入液体。当隔膜片到达终点，配气阀机构自动将压缩空气引入泵腔另一端，推动隔膜片朝相反方向运动，从而使两个两个隔膜片在泵体的两个腔做往复运动抽动液体流动。When the compressed gas enters the valve, the valve will press the compressed gas into the pump, which pushes the diaphragm movement to squeeze the liquid out. However, the other pump of the pump is sucked into the liquid because it is pulled out. When the diaphragm reaches the end point, valve mechanism automatically compressed air into the pump cavity and the other end, push the diaphragm in the opposite direction, thus making the two two diaphragm reciprocating motion in the two chamber of the pump body with liquid flow.

进口铸钢气动隔膜泵应用领域：

1、气动隔膜泵可以吸花生酱、泡菜、土豆泥、小红肠、果酱苹果浆、巧克力等。
2、塑料气动隔膜泵可以用于吸油漆、树胶、颜料。
3、粘合剂和胶水、全部种类可用泵吸取。
4、各种瓦、瓷、砖器及陶器釉浆。
5、油井钻好后，用气动隔膜泵吸沉积物及灌浆。
6、吸各种乳剂和填料。